Velleman VTLAMP10 User Manual download pdf (Page 2)

VTLAMP10

03.03.2011

USER MANUAL

1. Introduction

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device after its lifecycle

could harm the environment.

Do not dispose of the unit (or batteries) as unsorted municipal

waste; it should be taken to a specialized company for recycling.

This device should be returned

to your distributor or to a local recycling service. Respect the local en

vironmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for choosing Velleman!

Please read the manual thoroughly before bringing this device into

service. If the device was damaged in transit, don't install or use it and co

ntact your dealer.

2. Safety Instructions

Keep the device away from children and unauthorised users.

Never

leave the magnifying lens unattended where direct sunlight may pass through it: this

creates a fire hazard. Please close the lens cover after each use.

Indoor use only.

Keep this device away form rain, moisture, splashing and dripping

liquids.

Always disconnect mains power when the device is not in use or when servicing or maintenance

activities are performed. Handle the power cord by the plug only.

There are no user-

serviceable parts inside the device. Refer to an authorized dealer for service

and/or spare parts.

3. General Guidelines

Refer to the Velleman

Service and Quality Warranty

on the last pages of this manual.

Keep this device away from dust and extreme heat.

Protect this device from shocks and abuse. Avoid brute force when operating the device.

•

Familiarise yourself with the functions of the device before actually using it.

•

All modifications of the device

are forbidden for safety reasons. Damage caused by user modifications

to the device is not covered by the warranty.

•

Only use the device for its intended purpose. Using the device in an unauthorised way will void the

warranty.

•

Damage caused by disregard of

certain guidelines in this manual is not covered by the warranty and

the dealer will not accept responsibility for any ensuing defects or problems.

4. Features

• 12W circular fluorescent lamp

• on/off switch

• table standard

• dioptre: 3 + 12

• supplied with electronic ballast

5. Replace the Lamp

Unplug the device and let the circular fluorescent lamp cool down before replacing it.

The lamp is located behind a plastic diffuser.

1. Gently bend the stem so that the diffuser points upwards.

2. Remove the 5 screws [X] holding

the plastic diffuser in place. Remove the diffuser carefully and

make sure not to drop the lamp.

Hold the lamp at the plastic ring and disconnect the lamp from the connector. Pull on the connector,

not the cables. Take out the defective lamp.

4. Install a new lamp (order code LAMP12/10) and insert the connector.

5. Put the diffuser back and fasten the screws [X].

Rev. 01

©Velleman nv