Velleman DCM267N User Manual download pdf (Page 4)

DCM267N

00 (04/11/2008) 4 Velleman

• Avoid body contact with ground potential (e.g. metallic terminals, output

sockets, lead clamp…) while measuring. Make sure to be electrically

insulated from ground during measurement.

• Calibration and repair must be performed by a qualified technician. Refer to

your local dealer.

4. Features

• LCD display with automatic polarity indication

• data-hold function

• DCV (max. 600V) and ACV (max. 600V) measurements

• ACA (max. 1000A) current measurements

• max. Ø for conductor: 30mm

• resistance measurements: max. 40Mohm

• frequency measurements: max. 10MHz

• temperature measurements: -50°C to 1,000°C

• diode test, continuity test and backlight

• K-type thermocouple measuring range: from -20°C to 1,000°C

• optional probes (not incl.):

SONDE890, SONDE8264

• duty cycle measurements : 0.5 to 99% @ pulse width of 100µs to 100ms

• capacitance measurement: max. 100µF

• safety: indoor use only (overvoltage Cat. II 600V)

5. Overview

Refer to the illustration on page 2 of this manual

1 current clamp 6 Hz - % select button

2 clamp trigger 7 range select button

3 rotary function switch 8 LCD display

4 data hold & backlight button 9 COM jack

5 mode select button 10

V  °C/°F jack

6. Operation

GENERAL

• When the range of the measured signal is unknown, start measurement

in auto-range mode, and then select range according to indicated value.

• The display shows “OL” when the present range limit is exceeded. Select

a higher range to continue measurement.

• Do not measure voltages > 600 V or current higher than 1000A. Never

turn the rotary function switch [3] during measurement.

• The device will go in sleep mode when no activity is detected for ±30

min.

• For all measurements: pressing the data hold button [4] freezes the

currently measured value until the data hold button [4] is pressed again.

The hold-mode is indicated by the word “HOLD” in the display.

• To switch on the backlight, press and hold the backlight button [4] for

about one second. To switch the backlight off, press and hold the

backlight button [4] again for ±1s. Note that the meter goes in HOLD

mode when switching the backlight on or off. Press the data hold button

[4] again to continue normal measurement.

• The meter starts in auto ranging mode. To select the range manually,

press the range button [7] (not for AC current, diode and continuity

measurements). To return to auto ranging, press and hold the range

button [7] for ±2 seconds.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Velleman DCM267N User Manual Page 4

Comments to this Manuals

Related products and manuals for Multimeters Velleman DCM267N