Velleman HAA85WP User Manual download pdf (Page 16)

HAM263D

00 (10/10/2008) VELLEMAN

• Format:

XXyyyyyy#

XX = 11 USER CODE 1 for arm/disarm control of part. 1

12 USER CODE 2 for arm/disarm control of part. 2

13 USER CODE 3 for arm/disarm control of the

whole system (partition 1 and 2)

yyyyyy = 4 to 6 digits

# = validation

e. Memorize frequently bypassed zones (“HOME” mode)

• HOME mode is only available for use with USER CODE 3 (whole system). However, partitions

can be bypassed by bypassing the zones within the partition one by one.

• Zone 8 (24 hour zone) is excluded from use in HOME mode

• Format:

HOMEyyyyyy#

HOME Press HOME button on keypad

yyyyyy = List of zones to be enabled, sequential e.g. 245 to

bypass zones 2, 4 and 5

# = validation

• To use the home mode, simply type USER CODE 3, and ; all programmed zones will

automatically be bypassed.

f. Keypad audible notification set-up

• Some audible notification can be passed on to the keypad. This is the case for the exit and entry

delay, after an alarm condition and for each key button press.

• Alarm conditions concerning battery low or AC power failure conditions are always ON.

• Passing these notifications through to the keypad will not affect the beep settings on the master

control unit.

• Note that confirmation beeps from the

-button and -button are always enabled.

14yyyy#

14 master code

yyyy = 4 digits: 0=beep disabled, 1=beep enabled (default)

digit 1 Beep for exit delay

digit 2 Beep for entry delay

digit 3 Beep after alarm condition

digit 4 Beep after each key button press

# = validation

g. Alarm detection response time

• The default zone response time is set to 500ms. This setting can be adjusted independently per

zone, depending on the conditions in that zone.

• The 8 digit code represents the 8 protection zones. The first digit is zone 1 and the last digit is

zone 8. By putting the timing codes into the specific digit to independently the desired response

time can be set.

15yyyyyyyy#

14 master code

yyyyyyyy = 8 digits, default setting = 3

1 25 ms

2 250 ms

3 500 ms

4 750 ms

# = validation

h. Reset system to default

• To reset the system to its default values, enter code 2100#.

• Except for the master code, all other values will be cleared or set to their default.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

Comments to this Manuals

No comments

Velleman HAA85WP User Manual Page 16

Comments to this Manuals

Related products and manuals for Numeric keypads Velleman HAA85WP