Velleman DTO6234N User Manual download pdf (Page 4)

DTO6234N_v2 VELLEMAN

Three values are stored in the memory:

• Press the MEM button to display the maximum value, the minimum value and the last measured value

respectively.

4. Battery Replacement

a. the battery symbol ( ) is displayed when the batteries need to be replaced (battery voltage < ± 5V).

b. open the battery compartment and remove the old batteries.

c. insert 1 x 9V battery. Faulty installation can permanently damage the device.

d. remove the batteries if the device is not to be used for some time.

5. Front Panel Description

1. reflecting tape strip

2. laser beam

3. display

4. MODE button

5. MEAS button

6. 6VDC input

7. MEM button

8. battery compartment

6. Use

Attach a small strip of tape to the target surface. Press the MEAS to switch on the tachometer. Select whether to

measure the RPMs (RPM) or the revolutions (REV) with the MODE button. Point the tachometer at the strip of tape

and hold the MEAS button pressed. The indicator should appear on the display when you point the beam at the

strip of tape.

7. Measuring Tips

Reflective Tape

Cut a square of tape of ± 1cm² and attach it to the target surface.

• the piece of tape should never cover more than half of the target area.

• a target surface that is reflective of its own accord should be painted black or covered with black tape prior to

applying the tape.

• make sure the target surface is smooth and clean when you apply the tape.

measuring time = meetduur = durée de mesurage

max. value

max. waarde

valeur max.

min. value = min. waarde =

valeur min.

last value = laatst gemeten waarde =

dernière valeur mesurée

displayed reading

weergegeven waarde

valeur affichée

Fig. 1

Fig. 2

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Velleman DTO6234N User Manual Page 4