Velleman VDPLOP1810RGBW User Manual download pdf (Page 5)

VDPLOP1810RGBW

V. 01 – 22/07/2013 5 ©Velleman nv

Mounting the device

• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable

norms.

• The carrying construction must be able to support 10 times the weight of the device for 1 hour

without deforming.

• The installation must always be secured with a secondary attachment e.g. a safety cable.

• Never stand directly below the device when it is being mounted, removed or serviced. Have a

qualified technician check the device once a year and once before you bring it into service.

• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

• Overhead mounting requires extensive experience: calculating workload limits, determining the

installation material to be used… Have the material and the device itself checked regularly. Do not

attempt to install the device yourself if you lack these qualifications as improper installation may

result in injuries.

• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.

• Make sure there is no flammable material within a 0.5 m radius of the device.

• Have a qualified electrician carry out the electric connection.

• Connect the device to the mains with the power plug. All devices must be powered directly off a

grounded switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat or

dimmer channel is used solely for 0 % to 100 % switching.

• The device has a power output to supply power to another device. When connecting several devices

in a daisy chain via this output, make sure that the total current does not exceed the power line’s

nominal current. Use power cables with an adequate section. If you do not use the power linking

feature, be sure to use the included screw-on cap to prevent any water from getting into the power

cords.

• The installation has to be approved by an expert before the device is taken into service.

DMX-512 Connection

• When applicable, connect an XLR cable to the female XLR output of a controller (not incl.) and the

other side to the male XLR input of the device. Multiple devices can be linked through serial linking.

The linking cable should be a dual core, screened cable with XLR input and output connectors.

• Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended

number of devices on a serial data link is 32 devices.

• A DMX terminator is recommended for installations where the DMX cable has to run a long distance

or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the

digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω

resistor between pins 2 and 3, which is then plugged into the XLR output socket of the last device in

the chain.

7. Operation

Touch panel lock

• The device has a password protected touch panel lock.

• To unlock the panel, tap the buttons UP-DOWN-UP-DOWN-ENTER.

• The touch panel can also be turned off (see section Control Panel Navigation below).

The device can be used in the following modes:

• stand-alone mode

• master/slave

• with a DMX512 controller.

7.2 Control Panel Navigation

Access the control panel functions using the four panel buttons located directly underneath the display.

From left to right:

Button Function

<MODE> used to access the menu or to return to a previous menu option

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comments to this Manuals

No comments

Velleman VDPLOP1810RGBW User Manual Page 5

Comments to this Manuals

Related products and manuals for Lighting Velleman VDPLOP1810RGBW