Velleman ALN006 User Manual download pdf (Page 21)

English

8.5.a Table of solutions

Problem Possible cause Solution

The radio doesn't switch on The battery pack is discharged and/or has not been

installed correctly.

Verify that the battery pack is charged and that it has been

correctly installed.

The radio switches off shortly

after it has been switched on

Discharged battery pack. Recharge the battery pack.

The battery pack does not

recharge

The battery-charger has not been connected or

installed correctly.

Inspect the connections of the battery-charger and the

installation of the batteries.

The radio switches on but is

unable to receive signals

The site of installation is too shielded. Move to an another area.

The volume is too low Adjust the volume.

Incorrect CTCSS or DCS Check that the CTCSS tone or DCS code corresponds to the

one set by the parties you are communicating with.

Noise is always present in

reception mode

The monitoring function is enabled. Disable the monitoring function.

It is not possible to

communicate with other parties

An incorrect radio channel has been selected. Select the same radio channel used by the parties you are

communicating with.

The radio is installed in a shielded area or is too far

from the party you are communicating with

Move to another area.

Incorrect CTCSS or DCS Check that the CTCSS tone or DCS code corresponds to the

one set by the parties you are communicating with.

Reception is fragmented and/or

disturbed

The signal is very weak. Try temporarily disabling the squelch by means of the

Monitoring feature.

The transmission distance is excessive and/or there

are obstacles in the transmission path

Move closer to the party you are communicating with or to

another area.

Other parties are using the same channel Checkthetrafcontheradiochannelbymeansofthe

Monitoring feature and select another channel if required.

The radio has been installed too close to equipment

that causes interference (televisions, computers, etc.)

Increase the distance between the radio and this equipment.

Received communications are

not clear

Thescramblerhasbeenconguredonadifferent

setting as compared to that of the parties you are

communicating with (all the parties should either

enable or disable the scambler).

Select the same scrambler setting of the parties you are

communicating with.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments

Velleman ALN006 User Manual Page 21

Comments to this Manuals

Related products and manuals for Walkie Talkies Velleman ALN006