Velleman К8058 User Manual

Total solder points: 63 Difficulty level: beginner 1  2  3 ⌧ 4  5  advanced 8 Channel RF transmitter ILLUSTRATED ASSEMBLY MANUAL H80

10 Setup Hold 'shift' until the LED lights to enter the 'set-up' mode. Choose one of the following options by pressing the corresp

11 15. PCB layout. PCB

12 VELLEMAN KIT NV Legen Heirweg 33 9890 Gavere Belgium Europe Info ?: http://www.velleman.be Modifications and typographical errors reserved © Vell

Specifications: • 433MHz operation • LED function/mode indication • Power supply: 3 AAA batteries (not included). • Dimensions: 150 x 58 x 20mm (

3 Assembly hints 1. Assembly (Skipping this can lead to troubles ! ) Ok, so we have your attention. These hints will help you to make this project s

4 1.3 Soldering Hints : 1- Mount the component against the PCB surface and carefully solder the leads 2- Make sure the solder joints are cone-s

5  LD1 : 3mm RED First : Mount this LED like in the drawing (fig. 1.0). Solder one lead, check the position, if necessary cor-rect it by heating

6 Construction  IC1 : VK8058 programmed Pic16F630. 9. IC. Watch the position of the notch!  Solder a wire of 8cm (Ø 0,20mm)to the negative (-)

7  First bend the battery lips over before closing the enclosure (fig. 5.0).  Connect now the wire that you earlier have mount to the negative

8  Close the enclosure with the supplied screws. 12. Assembly Assembly Velleman ® DO NOT FASTEN THE SCREWS TOO TIGHT!

9 13. Keyboard Layout Keyboard layout & use 1 3 5 7 2 4 6 8 SHIFT When the batteries are inserted for the first time : Channels 1